The hearing instrument will mix the signals from the
shoe with the microphone so that you can listen to both
sources. The hearing instrument will beep twice in this
mode: one lower frequency beep followed by a higher
frequency beep.
It is possible to switch from this combined setting by
pressing the push button so that the hearing instrument
is only amplifying the signal from the FM shoe or DAI
shoe. The hearing instrument will beep three times in
this mode: one lower frequency beep followed by two
higher frequency beeps.
If the push button is pressed again, only the sound from
the hearing instrument microphone will be amplified.
The hearing instrument will beep once in this mode.
Note: The telecoil and second program will not func-
tion with the FM or DAI shoe in place. To access these
functions remove the FM or DAI shoe from the hearing
instrument.
Note: The safety of hearing instruments with DAI
(Direct Audio Input) is determined by the external
signal source. When the DAI is connected to an elec-
trically powered device, the equipment must comply
with EN 60601-1-1, EN 60065 or equivalent safety stan-
dards.
17
To Next Page
Loading...
