4
SAFETY
This device complies with current applicable safety standards.
Installation, maintenance, and use of this unit require a skilled and
trained staff.
Please carefully read this whole document before mounting and
starting-up the actuator.
PACKAGING, STORAGE AND MAINTENANCE
2.1 Packaging
BT actuators packaging is comprised of a dual-layer carton strapped
on a pallet. For certain non-EU countries or on request, the pallets
are heat treated to standard NIMP 15 and IPPC-stamped.
This packaging is identical for shipping by road, air or sea, unless
otherwise provided in the contract.
2.2 Storage
Actuators should be stored under a shelter, in a clean and dry place
and at a stable ambient temperature.
Avoid placing the actuator directly on the floor
Check that plugs of cable entries are correctly tightened.
Check that cover screws are correctly tightened to ensure
weatherproof sealing of the cover
BT actuator includes electrical components and lubricated gear
stages. Even with a weatherproof enclosure, oxidation, seizing and
other alterations may occur if actuator is not correctly stored.
What to check after storage
1. Visually check the electrical equipment.
2. Manually operate buttons, selectors, etc., to ensure their
proper mechanical functionality.
3. Manually operate the actuator for a few travels.
Heating resistor should be connected to power supply especially if
the storage place is wet.
To Next Page
Loading...