Bernina 2500DCET - Chain Stitch Threading

53
Chain stitch threading (position G)
1
2
3
4
5
6
7
9
10
2
8
Place the spool on the spool
pin as illustrated.
Chain stitch looper (purple markings)
1. Bring the thread up from
the spool and lay it from
the back to the front into
the guide.
2. Thread the first guide.
3. Take the thread through
the groove.
4., 5., 6., 7. Thread the
guides.
8. Press the auto threader
down.
9. Thread the slit of the
threader. Push the auto
threader lever up and it
will return to its normal
position.
10. Thread the looper eye.
Leave thread end
(8 cm or 3") hanging in
the machine.
2500_DCE_2_englisch_neu 09.10.2007 15:00 Uhr Seite 53