56
Chain stitch sewing test and fine tuning
Securing the seam end
After removing your work turn it over to the wrong side.
Secure the seam by pulling the loop (1) towards the left. If the
looper thread is subsequently pulled to the upper side, the
needle thread loops (2) are visible in the stitch formation and
can also be pulled through to the wrong side and knotted.
Note:
It is not necessary to secure the seam begin, because the
first stitch is automatically knotted by the subsequent
stitches.
1
2
3
Unpicking seams
The chain stitch formation can be unpicked from the seam
end by pulling the looper thread (3). The needle threads can
then be removed from the right side.
2500_DCE_2_englisch_neu 09.10.2007 15:01 Uhr Seite 56
To Next Page
Loading...
