Need help?Do you have a question about the Bernina 700 Series and is the answer not in the manual?
General| Memory Function | Yes |
|---|---|
| Color Touch Screen | Yes |
| Automatic Thread Cutter | Yes |
| LED Sewing Lights | Yes |
| Maximum Embroidery Speed | 850 stitches per minute |
| USB Port | Yes |
| Free Arm | Yes |
| Sewing Speed | 1000 stitches per minute |
| Built-in Stitches | Over 200 |
Advises on dangerous voltages and static electricity buildup during machine operation.
Step-by-step instructions for removing and replacing the feed dog eccentric mechanism.
Guide on leveling feed dogs using shims and aligning them with the needle plate.
Procedure for identifying and replacing the stitch length lever on Model 830.
Instructions for removing and replacing the cam stack gear for proper stitch function.
Detailed steps for removing, disassembling, and reassembling the take-up lever assembly.
Procedure for removing and reinstalling the buttonhole mechanism for repair.
Instructions for disassembling, cleaning, oiling, and reassembling the changeover lever unit.
Guide for removing the presser foot bar for cleaning and checking movement.
Procedure for installing the stitch length stop clamp and related components.
Guidance on replacing the spring support for the changeover knob if it becomes loose.
Steps for removing and exchanging the bobbin winder for models 730 and 830.
Procedure for removing, cleaning, and installing the sewing/darning mechanism.
Instructions for correcting the stitch width knob on the 730 model, including soaking.
Details on the components and function of the long and basting stitch mechanism.
Correction procedure for the needle bar guide and clutch engagement.
Instructions for servicing the needle bar clutch, including cleaning and lubrication.
Procedure for adjusting the needle bar cushioner to a high position for next adjustments.
Check and correction steps for the control lever's swing and resting position.
Procedure for setting stitch width and changeover lever for control cam alignment.
Marks handwheel for needle bar decoupling shortly before top dead center.
Procedure for setting the bearing plate for the needle stop up function.
Adjustment steps for the latch lift mechanism, ensuring correct clearance and clicking sounds.
Guide on positioning the take-up lever correctly for old and new style adjustments.
Detailed adjustments for the needle stop down feature on specific models.
To Next Page
