Bernina Sewing Machine - Rolled and Whipped Edge

Mastering
Your
BERNINA
®
BERNINA
®
/bernette
®
Sewing Machines
MASTERING YOUR BERNINA
®
/bernette
®
SEWING MACHINE 8/05
50
Notes
©2005 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA
®
Dealers
Fabric .................................................... lightweight cotton, 6” x 4”
Needle ................................................................... 80/12 Universal
Thread .......................................................................... all-purpose
Presser Foot ........... BERNINA
®
Standard Buttonhole Foot #3/3C
......................................... bernette
®
Clear Satin Stitch Foot
Stitch .................................................................................. zigzag
Needle Position ......................................................................... left
Rolled and Whipped Edge
Clean one 6” lengthwise edge of “whiskers”
Select the Zigzag Stitch (BERNINA
®
SW = 2.5mm and SL =
1mm or less; bernette
®
SW = 3.5mm and SL = buttonhole setting).
Loosen the top tension if necessary.
bernette
®
Place cut edge of fabric against
the inside of the right toe of the
foot and sew.
BERNINA
®
Place cut edge of fabric be-
tween the center and left toes of
the presser foot and sew.
Notes:
- The left swing of the needle should be in the fabric, while the
right swing falls off of the right edge of the fabric.
- As needle swings left, it should roll fabric into a tiny rolled edge.
- The finer the fabric, the finer the needle and thread used.
Trim and mount the sample.
This edge finish is used on a single thickness of fine lightweight
fabrics. It is also use as a seam finish or as an edge on ruffles,
hems, etc.