Bertin Technologies PRECELLYS Evolution Touch User Manual

Page 39Page 38
PRECELLYS EVOLUTION
PRECELLYS
®
Evolution Touch
USER MANUAL
11.2.2 Preparing Precellys® Evolution Touch
11.2.3 Positioning the original packaging
11.2.4 Packing
1. Open the lid and
place the black foam
padding inside.
5. Place the blocking
plate and tubes
together as in the gure
and place them into
the special cutout of
the top foam.
1. Close the box with
strong packing tape
when ready.
2. Place the box on a
pallet and secure it with
strapping.
1. Place the cardboard
inserts on a at surface
and position the
bottom foam at its
center.
3. Place the Precellys®
Evolution Touch in the
box using the handles.
Close the lid
2. Place the Precellys®
Evolution Touch in its
space, while ensuring that
the housing and feet are
fully inserted into the foam.
4. Place the upper foam.
Do not hold the device by the lid when putting it in
its box. It must be held using either the extraction
handles provided or by holding the equipment from
underneath at the notches provided on the side of the
casing. There are also notches provided in the lower
protective foam pad.
Given its mass, the device should preferably be
handled by two operators.
Handle the device with care as signicant shocks can
damage the equipment.

Bertin Technologies PRECELLYS Evolution Touch Specifications

General

Brand	Bertin Technologies
Model	PRECELLYS Evolution Touch
Category	Laboratory Equipment
Language	English