Bertolini BTS 80 - Page 104

25
Chapter 6: Maintenance and controls
Section 2 Regular and exceptional maintenance
Fig. 6.3
11 10 12
Fig. 6.2
Fig. 6.4
Engine
Check every day the oil level and if
necessary fill up (Fig. 6.2).
Use only ESSO UNIFARM 15 - 40 W oil
and ESSO MULTIPURPOSE grease.
Complete renewal of the engine oil
needs to be done at intervals and in
specific ways as established by the
Builder of the engine.
For further information consult the
use and maintenance booklet of the
engine.
Adjustment of the levers
Should the machine not stop
immediately when releasing the vehicle
clutch Lever (Fig. 6.3), the clutch lever
needs adjusting. The same goes for
the rotor blade clutch lever, when the
blade roller takes too much time to
stop.
As for the clutch Lever, adjust the
registers positioned on either side of
the command levers (Fig. 6.3).
For the wheel unlock levers and the
gear Lever (Fig. 6.4) you need to do
the same. When you notice the levers
are not well fixed, check that there is
no more than 1÷2 mm movement.
Should these adjustments not be
sufficient and your walking tractor
present further problems, please
do not hesitate to contact your
Sales Representative or Dealer
immediately.
S
hould these adjustments not be
sufficient and your walking tractor
p
resent further problems, please
d
o not
h
es
i
tate to contact your
Sales Representative or Dealer
i
mme
di
ate
ly
.