Best K29 - Install Filters; Grease Filter Installation; Ductfree Filter Installation

- 12 -
INSTALL FILTERS
DUCTED CONFIGURATION ONLY
1. To remove the GREASE filter, grip the latch
tab and pull it down. This will disengage the
filter from the hood. Tilt the filter downward
and remove.
2. To install the GREASE filter, align rear filter
tabs with slots in the hood. Pull latch tab
down, push filter into position and release.
Make sure the filter is securely engaged
after assembly.
DUCTFREE FILTER
INSTALLATION
DUCTED CONFIGURATION ONLY
1. Purchase a ductfree filter kit (model no.
FILTERK3490CM or FILTERK3448) from
your dealer.
2. Remove the grease filters by pushing them
back to compress the retaining springs, then
tilt filters down and out of front groove.
3. Holding the ductfree filter on its side, insert
one of the support rods, (supplied with fil-
ters) into the upper groove in back that runs
parallel with the front of the hood, in order
to avoid that the filter might be sucked onto
the motor.
4. Fold the filter and insert it into the front.
GREASE FILTERS
GROOVES
DUCTFREE
FILTER
SUPPORT
ROD
SUPPORT
ROD