Bestar Murphy 26183-5 - User Manual

http://bestar.ca
http://bestar.com
•
Bed frame maximum supporting weight: 1000 lb (455 kg).
•
Maximum mattress thickness: 10 in (25.5 cm).
•
Mattress weight must be between: 60 lb (27 kg) and 90 lb (41 kg).
•
Minimum ceiling height: 85.75 in (2.18 m).
•
Minimum holding force required for each fastener: 142 lb (630 N).
•
Not for use with folding mattress.
NOTICE
Important information to read
before starting the assembly.
Keep this information for future reference.
MODEL
COLOR
WO
26183-5
IMPACT OR CRUSHING HAZARD: If bed is not properly attached to the wall,
it can suddenly fall, resulting in serious injury or death.
•
For wood or masonry wall structure, a qualified person must install the bed to the wall.
•
For all other types, a construction professional must install the bed to the wall in compliance
with the codes and regulations in the province, state, or country where installed.
•
The choice of wall attachment screw depends on wall type. Use wall attachment screws
suitable for your wall material.
•
Verify structural integrity of floor and wall prior to installation.
•
Do not open or use the bed if the bed cabinet moves while opening, or if you notice any other
signs of loose or detaching screws.
•
Never remove wall attachment screws without first disassembling and removing the mattress
frame and lift cylinders.
•
Qualified person must have the skills and tools necessary to locate wall studs, identify type
of wall structure (wood, metal, masonry or other) and install screws correctly to wall structure.
Skills and tools include electronic stud finder, drill motor and bits, screwdriver, and ability
to correctly use these tools.
WARNING
FOR ANY PROBLEM OR INFORMATION
1-888 8BESTAR (1-888 823-7827)

Summary

Safety and General Information

General Safety Warnings

Critical warnings about impact, crushing hazards, and correct installation.

Product Specifications

Weight limits, mattress thickness, ceiling height, and other key notices.

Critical Usage Warnings and Cautions

Risk of Serious Injury and Fire

Warnings concerning suffocation, fire hazards, and potential injury from misuse.

Operational Cautions

Cautions on overloading facades and proper leg operation.

Product Information and Support

Warranty Details

Details regarding the product's warranty coverage and conditions.

Customer Service Contact

Information on how to reach customer service for assistance.

Parts and Hardware Identification

Component Parts List

Identifies all individual furniture parts required for assembly.

Hardware List and Specifications

Lists all hardware pieces required for assembly, including sizes.

Wall Anchoring Instructions

Cabinet to Wall Structure Attachment

Step-by-step guide for securing the cabinet to the wall structure.

Wood Stud Wall Anchoring

Specific instructions and hardware for anchoring to wood studs.

Masonry Wall Anchoring

Specific instructions and hardware for anchoring to masonry walls.

Assembly Steps

Required Tools and Assembly Notices

Lists necessary tools and provides important assembly advice.

Initial Hardware Installation

Instructions for the first phase of hardware installation.

Final Cylinder Tightening

Guidance on properly tightening cylinder nuts for correct operation.

Preparing for Facade Attachment

Securing the bed for the installation of decorative facades.

Disassembly Instructions

Initial Disassembly Steps

Steps to remove mattress, slats, and facades from the bed.

Final Disassembly Steps

Procedures for removing bearing supports, frame, and wall attachment.

Bestar Murphy 26183-5 Specifications

General

Product Type	Murphy Bed
Assembly Required	Yes
Mattress Included	No
Color	White
Shelves Included	Yes
Frame Material	Wood