YOUR ONE SOURCE
Manual Sidedrive Dual Mast Carton Sealer (MSD)
20
Troubleshooting
PROBLEM POSSIBLE CAUSE CORRECTION
6. Tape not centered
on box
Tape drum not centered Reposition tape drum *
Top compression rollers not
aligned with the tape head
Align the left and right compression roller to
the tape head *
Box fl aps not of equal
length
Check box specifi cations and adjust
accordingly
7. Blade does not cut
tape, or tape end is
jagged or shredded
Blade is dull and/or has
broken teeth
Replace blade *
Tape tension is insuffi cient
Increase tape tension by adjusting the
mandrel wheel *
Adhesive has build-up on
blade
Clean and adjust the blade *
Blade not positioned
properly
Check that the blade is bottomed out against
the mounting bolts *
Blade is dirty
Clean blade and lubricate the oiler pad on the
blade guard *
Blade in backwards
Mount the blade so that the beveled edge is
away from the entrance end of the head *
Blade spring guard Replace the defective spring
TROUBLESHOOTING (cont’d)
To Next Page
Loading...