EN
16
3.2.10 Temperature
> Overload Protection: 250V DC or rms AC
4. OPERATING INSTRUCTION
4.1 DATA HOLD
If you need hold when measuring, you can put on “H”, it will hold the reading; if you put the
button again, data hold is not continue.
4.2 BACK LIGHT
If the light is dark to make the reading difficult when measuring, you can put on “✲” to open the
back light.
NOTE: LED is the main source of back light. Its working current is large, al-
though the meter has the timer equipment (time is 5 seconds and it will off
automatically after 5 seconds); often use back light will shorten the battery
Range Resolution Accuracy
-20° to 1000°C 1°C
-20°C to 0°C
0°C to 400°C
400°C to 1000°C
±(5.0% of rdg +5 digits)
±(1.0% of rdg +3 digits)
±(2.0% of rdg +3 digits)
MultimetroDigitale.book Page 16 Friday, September 26, 2003 6:34 PM
To Next Page
Loading...