EN
5
1.4 MAINTENANCE
• Please do not attempt to adjust or repair the meter by removing the rear case while voltage is
being applied. A technician who fully understands danger involved should only carry out such
actions.
• Before opening the battery cover of the meter, always disconnect test leads from all sources of
electric current.
• For continue protection against fire, replace fuse only with the specified voltage and current
ratings: F1: F 200mA/250V (quick acting), F2: F 10A/250V (quick acting)
• Do not use abrasives or solvents on the meter, use a damp cloth and mild detergent only.
• Always set the power switch to the OFF position when the meter is not in use.
• If the meter is to be stored for a long period of time, the batteries should be removed to pre-
vent damage to the unit.
MultimetroDigitale.book Page 5 Friday, September 26, 2003 6:34 PM
To Next Page
