EN
4
• Never connect the meter leads across a voltage source while the function switch is in the cur-
rent, resistance, diode or continuity mode. Doing so can damage the meter.
• When carrying out measurements on TV or switching power circuits always remember that
there may be high amplitude voltages pulses at test points, which can damage the meter.
• Never perform resistance measurements on live circuits.
• Never perform capacitance measurements unless the capacitor to be measured has been dis-
charged fully.
• If any faults or abnormalities are observed, the meter can not be used any more and it has to be
checked out.
• Never use the meter unless the rear case is in place and fastened fully.
• Please do not store or use meter in areas exposed to direct sunlight, high temperature, humidi-
ty or condensation.
1.3 SYMBOLS
Important safety information, refer to the operating manual.
Dangerous voltage may be presence.
Double insulation (Protection class II).
Earth ground.
MultimetroDigitale.book Page 4 Friday, September 26, 2003 6:34 PM
To Next Page
Loading...
