EN
11
Capacity Measurements
Warning: to avoid electric shock, disconnect power to the unit under test and discharge all
capacitors before taking any capacitance measurements. Remove the batteries and unplug the
line cords.
Set the rotary function switch to the cap position.
Insert the black test lead banana plug into the negative (COM) jack.
Insert the red test lead banana plug into the positive V jack.
Touch the test leads to the capacitor to be tested.
Read the capacitance value in the display
Frequency or % duty cycle measurements
Set the rotary function switch to the “Hz/%” position
Insert the black lead banana plug into the negative COM jack and the red test lead banana
plug into the positive V jack.
Select Hz or % , duty with the Hz/% button
Touch the test probe tips to the circuit under test.
Read the frequency on the display.
Temperature Measurements
Warning: to avoid electric shock, disconnect both test probes from any source of voltage befo-
re making a temperature measurement.
Set the function switch to TEMP.
1
2
3
4
1
2
3
4
5
1