Beta 1760/RMS - Page 37

37
EN
DC current measurement
Insert the black test lead banana plug into the negative (COM) jack.
For current measurements up to 110µA DC, set the function switch to the uA position and insert
the red test lead banana plug into the (µA) jack.
For current measurements up to 110mA DC, set the function switch to the mA range and insert
the red test lead banana plug into the (mA) jack.
For current measurements up to 10A DC, set the function switch to the A position and insert the
red test lead banana plug into the 10A jack.
Press the AC/DC button until “DC” appears in the display.
Remove power from the circuit under test, then open up the circuit at the point where you wish
to measure current.
Touch the black test probe tip to the negative side of the circuit. Touch the red test probe tip to
the positive side of the circuit.
Apply power to the circuit.
Read the current in the display. The display will indicate the proper decimal point, value and
symbol.
1
2
3
4
5
6
7
8
9