Beta 1760/RMS - Frequency.measurement; Temperature.measurement

42
EN
FREQUENCY MEASUREMENT
Set the function switch to the Hz position.
Insert the black test lead banana plug into the negative (COM) jack and the red test lead banana
plug into the positive Hz jack.
Touch the test probe tips to the circuit under test.
Read the frequency in the display. The digital reading will indicate the proper decimal point,
symbols (kHz, MHz) and value.
TEMPERATURE MEASUREMENT
Set the function switch to the ºC position.
Insert the Temperature Probe into the input jacks, making sure to observe the correct polarity.
Press the MODE button until “ºF or ºC” appears in the display.
Touch the Temperature Probe head to the part whose temperature you wish to measure. Keep
the probe touching the part under test until the reading stabilizes (about 30 seconds).
Read the temperature in the display.
Note:
The temperature probe is tted with a type K mini connector. A mini connector to banana connector
adaptor is supplied for connection to the input banana jacks.
1
2
3
4
1
2
3
4
5