53
EN
BATTERY INSTALLATION
WARNING:
To avoid electric shock, disconnect the test leads from any source of voltage before removing the
battery cover. Do not operate the instrument with the battery cover removed
Disconnect the test leads from the meter.
Open the battery cover by loosening the screw using a Phillips head screwdriver.
Insert the battery into battery holder, observing the correct polarity.
Put the battery cover back in place. Secure with the two screws.
Note:
If your meter does not work properly, check the fuses and battery to make sure that they are still
good and that they are properly inserted.
1
2
3
4
To Next Page
Loading...
