•
D
o not disassemble the unit, it may result in injuries.
•
W
hen applying the cu, make sure there are no
wrinkles in the cu. This could cause bruises.
•
I
f you are allergic to plastic/rubber, please dont use
this device.
•
B
lood pressure measurements can lead to
temporary marks on the skin at the site of the
cu placement. This is especially the case in
high repetition rates, in hypertonic patients and in
patients with weak pulses. In rare cases a mark may
persist for a couple of days. Please contact your
physician about these specific risks of cu pressure
in your specific case.
•
F
or hygienic reasons the cu is intended only for
the use by one person.
•
C
ardiovascular diseases may lead to incorrect
measurements or have a detrimental eect on
measurement accuracy. The same also applies
to very low blood pressure, diabetes, circulatory
disorders and arrhythmias as well as chills or
shaking.
•
P
rolonged over-inflation (cu pressure exceeds
300 mmHg or maintained above 15mmHg for
longer than 3 minutes) of the bladder may cause
ecchymoma of your arm.
•
P
lease note that when inflating, the functions of the
limb in question may be impaired.
•
T
he accuracy of any blood pressure measurement
with this device can be aected by a multitude of
causes. Some can be avoided some have to be
accepted at the time of measurement. Speak with
your physician about possible causes aecting your
blood pressure.
•
D
o not inflate the cu unless wrapped around wrist.
•
D
o not touch the unit and cu and/or press any
buttons when measurement is in progress, except
for stopping the measurement. Doing so may cause
incorrect readings.
•
T
he use of the device may be limited in the presence
of electromagnetic disturbances. This could result
in issues such as error messages or the failure of
the display/device.
•
A
void using this device directly next to other devices
or stacked on top of other devices, as this could
lead to faulty operation. If, however, it is necessary
to use the device in the manner stated, this device
as well as the other devices must be monitored to
ensure they are working properly.
•
T
he use of accessories other than those specified
or provided by the manufacturer of this device can
lead to an increase in electromagnetic emissions
9
To Next Page
Loading...
