What to do if Beurer FT 60 Thermometer shows temperature too high?
If your Beurer Thermometer displays a temperature higher than 42.2 °C (108 °F) in forehead mode or higher than 80 °C (176 °F) in SCAN mode, make sure you are operating the thermometer within its specified temperature ranges. If the issue persists, try cleaning the sensor tip. If the error continues, contact your dealer or customer service.
What to do if my Beurer FT 60 Thermometer is not working?
If your Beurer Thermometer is not functioning correctly, remove the battery for about 1 minute and then reinsert it. If the error message reappears, it is recommended to consult your dealer or customer service.
What to do if Beurer FT 60 Thermometer shows temperature too low?
If your Beurer Thermometer displays a temperature lower than 34 °C (93.2 °F) in forehead mode or lower than -22 °C (-7.6 °F) in SCAN mode, ensure that you are using the thermometer within the correct temperature range. If the problem continues, try cleaning the sensor tip. Should the error message persist, contact your dealer or customer service.
What to do if the autotest is not successful on Beurer FT 60?
If the autotest on your Beurer Thermometer was not successful, try inserting a new battery.
How to stabilize Beurer Thermometer with ambient temperature?
If you are experiencing large fluctuations in ambient temperature while using the Beurer Thermometer, store the device for at least 30 minutes in the room where you plan to take the measurement.
General| Brand | Beurer |
|---|---|
| Model | FT 60 |
| Category | Thermometer |
| Language | English |
To Next Page
