Beurer LB 88 - Troubleshooting

22
10. What if there are problems?
Problem Cause Solution
The operating loop
does not light up.
The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
Turn the control dial clockwise towards the ma-
ximumposition.
No LED display. The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
Turn the control dial clockwise towards the ma-
ximumposition.
Red LED display.
Thewaterlevelistoolow;thewater
tank is empty.
Fillthewatertank.
No mist is produced. The LED display lights up red. Fillthewatertank.
The LED display does not light up. Connect the plug.
The mist has a
strange smell.
Thedeviceisnew. Removethewatertank,turnthescrewedplug
andremoveit.
Air the open, empty water tank in a cool, dry
placefortwelvehours.
Stale or dirty water. Empty the base unit and the water tank and
clean them thoroughly.
Fillthewatertankwithfreshwater.
Strange noise. The water tank is not positioned
correctly on the base unit.
Lift up the water tank and position it correctly
on the base unit.
The tank should sit tightly on the base unit.
Strange noise. There is too little water in the water
tank.
Fillthewatertank.
Thedeviceisnotlevelandunstable. Placethedeviceonafirm,levelsurface.
Mist escapes from
underneath the
water tank.
The water tank is not positioned
correctly on the base unit.
Lift up the water tank.
Check whether the join between the base unit
and water tank is clean.
Clean if required.
Position the water tank correctly on the base
unit.
The tank should sit tightly on the base unit.
11. Technical data
Dimensions(LxWxH) Approx.29.5cmx19.5cmx28cm
Cable length Approx.1.4m
Weight when empty Approx.2.24kg
Mainsvoltage/frequency 220-240VAC/50/60Hz
Nominal power 280W
Room size Upto48m
2
Maximumcapacity Approx.6litres
Evaporationoutput 550ml/hour
Signs and symbols
The unit is double-protected and thus corresponds to protec-
tion class 2.