EasyManua.ls Logo

Beurer LB 88 - Operation and Cleaning; Device Operation; Cleaning and Storage

Beurer LB 88
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
IMPORTANT
Donotaddanyessentialoilsorfragrancestothewater.Ifotheradditivesareused,theplastic
material and the ultrasound membrane may become discoloured and damaged.
Usefreshdrinkingwaterinthedevice.
Positioning the device
Placetheairhumidifieronafirm,levelandwater-resistantsurface.
Positiontheairhumidifierinthevicinityofaheatingpadtoimproveevaporationoutput,particularlyin
largerooms(donotexceedamax.temperatureof50°C).Alwaysensurethattheairinletandairoutlet
remain clear and that the air flows freely.
7. Operation
IMPORTANT
Checkthehumidityofyourambientairregularly.Intensivecontinuousoperationcancausetheam-
bientairtobecomeexcessivelyhumid.Therelativeairhumidityshouldnotexceed60%.
Switching on the device
•
I
nsert the plug into the mains socket.
•
F
rom the min./ position, turn the control dial to the right. The blue illuminated operating loop lights
up.Ifthereisnotenoughwaterornowateratallinthewatertank,aredLEDlightsup.Thedevicehas
switched off for safety reasons.
•
U
sethecontroldialtosetthedesiredevaporationoutput.Evaporationoutputislimitedtoamaximum
of550mlperhour.
• Whenthedeviceisswitchedon,thewaterevaporationlevelisalreadysetto1;asingleblueLEDshows
the operation. By pushing the middle control knob (
),thewaterevaporationlevelincreasesto2(second
blueLEDlightsup).Bypressingitagain,bothLEDsturnon–level3.(Evaporationlevel).Theevaporation
process is switched off completely when the button is pressed again (no LED on).
•
C
heckthewaterlevelregularlyduringoperationandrefillthetankifnecessary.
Note
You may optionally add drops of aroma/scented oils to the aroma compartment (13). These will lend
a pleasant odour to the room.
8. Cleaning and storage
Regular cleaning is a prerequisite for hygienic and fault-free operation.
The air humidifier can be dismantled easily and without tools for cleaning.
Alwaysemptyandthoroughlycleantheairhumidifierifthedevicecontainswaterandhasnotbeenoperated
for longer than 3 days.
A lack of cleaning and hygiene can cause bacteria, algae and fungi to form in the water.
Inanycase,werecommendthefollowingcleaningintervals.
Every three
days
As required
x Cleaning the ultrasound membrane with a brush, rinsing the base
x Rinsing the water tank, replacing the water
x Clean the air humidifier inside and out
x Descaling
NOTE
•
C
leanthedeviceusingonlythemethodsspecified.
•
U
nder no circumstances may liquid enter the base unit.
•
D
onotuseanysolvent-basedcleaningproducts.

Other manuals for Beurer LB 88

Related product manuals