Bevel Tools Becel Mate EBA-12 - General Notes of Safety; Use of the Machine for Purposes for Which It Is Intended; Incorrect Use; CE Declaration of Conformity

2
1.1 General notes on safety
This operation manual is applicable for the machines
EBA-12
EBA-12S
The machines may only be handled by personnel who are qualified. Hold power tools by insulated
gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its
own cord. Contact with a «live» wire will make exposed metal parts of the tool «live» and shock the
operator.
WARNING Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
1.2 Use of the machine for purposes for which it is intended
The machines are intended for the purpose of beveling of metal and plastic materials without the use of
water.
1.3 Incorrect use
All uses other than those described under section 1.2 are regarded as incorrect use and are therefore
not admissible.
1.4 CE declaration of conformity
Beveltools BV of P.O.box 190, 6880 AD Velp Gld, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) complies with the requirements under the
Directive 2004/108/EC, 2006/42/EC, 2011/65/EU. Applied standards: EN ISO 12100, EN 60745,
EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3. Document
Agent: J.E. Hofman, July 2014 J.E. Hofman Managing Director
1.5 Symbol legend
Attention!
Make sure to read!
This information is very important for ensuring correct operation of the product. Failure to observe this
information can result in a defect.
Note on safety / Warning
This information serves to achieve safe operation. Failure to observe this information may compromise
the operator‘s safety.
Information
This information serves for a good understanding of the operation of the product, thereby permitting
full exploitation of the operational potential of the product.
Technical Document
Read the technical document prior to commissioning.
Safety glasses and ear protection.
Wear safety glasses and ear protection.