4
2.2.1 Turn on
• Make sure you always have a firm footing when working with the machine.
• Whatever the position of the machine, always use two hands to control the machine.
• Never touch the milling head when the machine is running.
• Never use the machine above head height.
• The machine should only be used for conventional up‐cut milling.
• To turn the machine on, push the ON/OFF switch toward the front.
• Bring the machine slowly into contact with the work piece only after the selected tool speed has been
reached.
• When cutting a bevel always move the machine from left to right against the direction of rotation of
the milling head.
• When machining bore holes, always work in a clockwise direction.
2.2.2 Turn off
• Take Beveling machine from work peace and turn off.
• Motor stops.
2.3 Rating data
Power voltage (cf. replacement parts list)
120/230V; 50/60 Hz; 120/230V
Sound pressure level according to EN 60745
Vibration according to EN 60745
The specified vibration value was measured with a standardized test procedure. It can be used to
compare products or to make an initial assessment of the exposure. The vibration emissions may differ
from the specified value, depending on how the power tool is used. Operating personnel must be
protected with defined safety measures based on the estimated exposure under the actual conditions of
use (these must take into account all phases of the operating cycle, e.g. the times when the power
tool is switched OFF and the times it is switched ON, but is not under load).
To Next Page
Loading...
