Bevel Tools Becel Mate EBA-12 - Prior to Taking the Machine into Service; Taking the Machine into Service

3
Disposal
Friendly-to-the-environment disposal.
Power connector
Before any work is carried out on the machine, disconnect the power connector.
2.1 Prior to taking the machine into service
Before connecting tool to a power source, be sure the voltage supplied is the same as specified on the
name plate of the tool. The power supply should not vary more than 10% above or below the voltage
indicated on the nameplate.
Working with worn or damaged router heads will cause the machine to fail.
• Check beveling tool prior to use.
• Sharp beveling tools will increase cutting speed and machine life.
• Beveling tools must be changed regularly.
• The beveling tool must be mounted centrally and positioned against the limit stop.
• The maximum allowable speed of the tool and of the chuck may not be exceeded under any
circumstances.
• Observe national regulations.
2.2 Taking the machine into service
Preselect speed with adjusting wheel according to speed table.
Adjusting wheel increment
Min
-1
/ rpm
1
4.200
2
5.200
3
6.400
4
7.600
5
8.800
6
10.000
During operation never increase the speed of the machine to above that of the maximum admissible
speed of the grinding tool!