Why is there noise/chirping with my Beyerdynamic Opus 600 Microphone system?
Noise or chirping can occur due to interference from other transmitters, having two transmitters on the same frequency, or a weak transmitter battery. Try switching off other transmitters, changing the frequency of one transmitter, or replacing/recharging the batteries.
What to do if my Beyerdynamic Opus 600 Microphone system has no function?
If your Beyerdynamic Microphone system isn't working, check the following: Ensure the transmitter and receiver are on the same frequency. Replace or recharge the batteries if the voltage is low. Also, inspect the batteries to ensure they are correctly inserted and have good contact.
What to do if my Beyerdynamic Microphone system has no reception?
If you're experiencing no reception with your Beyerdynamic Microphone system, first, ensure the transmitter is switched on. If it is on, verify that the transmitter and receiver are set to the same frequency, using the ACT function to adjust if necessary. If you are using remote antennas, inspect the antenna cables for any defects.
How to fix distorted sound on my Beyerdynamic Microphone system?
If you are experiencing distorted sound with your Beyerdynamic Microphone system, the input amplifier of the connected mixer might be overloaded. Try using the gain control on the mixer or adjusting the volume.
What to do if my Beyerdynamic Opus 600 Microphone system has no sound and AF indication is missing?
If your Beyerdynamic Microphone system shows no sound, but the RF indication is okay while the AF indication is missing during modulation, strong interference signals may be causing a wrong indication. Try selecting another frequency. Also, check that a suitable microphone is connected to the TS 600 beltpack transmitter; connect one if none is present.
Why Beyerdynamic Opus 600 has no RF indication at the receiver?
If there is no RF indication at the receiver of your Beyerdynamic Microphone system, it could be that the transmission distance between the transmitter and receiver is too great. Try reducing the distance between them.
General| Max SPL | 130 dB |
|---|---|
| Frequency Range | 863 - 865 MHz |
| Modulation | FM |
| RF Output Power | 10 mW |
| Connector | XLR |
| Weight (Transmitter) | 300 g |
| Sensitivity | -45 dBV/Pa |
| Operating Range | 100 m (line of sight) |
Safety instructions and warnings specific to the NE 600 diversity receiver.
Safety guidelines and precautions for the S 600 handheld and TS 600 beltpack transmitters.
Instructions for the proper disposal of electronic equipment and used batteries.
Identification of front and rear panel controls and indicators for the NE 600 receiver.
Instructions for connecting the antennae to the NE 600 diversity receiver.
Guidance on the optimal placement of the diversity receiver for best performance.
Details on audio output and power connections for the NE 600 receiver.
Step-by-step instructions for powering on and operating the NE 600 receiver.
Guide on how to adjust the squelch control to minimize noise.
Procedures for selecting channels and frequencies on the NE 600 receiver.
Instructions for using the ACT function to synchronize frequency with the transmitter.
Steps for installing the NE 600 S and NE 600 D receivers into a 19-inch rack.
Advice on connecting and positioning remote antennae for optimal reception.
Identification of the controls and indicators on the ZAS 800 antenna splitter.
Instructions and diagrams for the installation of the ZAS 800 antenna splitter.
Important general information regarding the ZAS 800 antenna splitter.
Identification of the controls and indicators on the S 600 handheld transmitter.
Step-by-step guide for inserting batteries into the S 600 handheld transmitter.
Instructions for powering on and operating the S 600 handheld transmitter.
Guide on how to change the microphone capsule on the S 600 transmitter.
Instructions for setting the low-cut filter on compatible microphone capsules.
Maintenance procedures for the S 600 handheld transmitter and its accessories.
Identification of the controls and indicators on the TS 600 beltpack transmitter.
Step-by-step guide for inserting batteries into the TS 600 beltpack transmitter.
Instructions for powering on and operating the TS 600 beltpack transmitter.
Guide on how to adjust the input gain for the TS 600 beltpack transmitter.
Details on connecting various audio sources to the TS 600 AF input.
General guidelines for safely changing batteries in Opus 600 transmitters.
Essential checks and setup procedures before a soundcheck.
Methods for resolving interference by repositioning transmitters.
Recommendations and techniques to avoid audio feedback.
Common problems and solutions for the NE 600 diversity receiver.
Common problems and solutions for the handheld and beltpack transmitters.
Detailed technical specifications for the NE 600 diversity receiver.
Technical specifications for SDM 660, SDM 669, and SEM 681 handheld transmitters.
Detailed technical specifications for the TS 600 beltpack transmitter.
Technical specifications for the ZAS 800 antenna splitter.
To Next Page
