BFC VMC Series - How to Adjust the Function Set Value

5
HTE402559 11/47
3. Push “Set” button to change the mode from
“Indication” to “Adjust”.
It enables alteration of the data appeared on the display
and the lowest digit blinks for alteration.
Note: On the Error Code and Version Information,
“Adjust” mode can not be selected.
Blinking
Alteration enable
Push button
1. Dial the selection dial and select the function turning on “Function” lamp.
Selection Dial
Dial
Turning on
-Continued-
How to operate the Control Panel
Function data appears.
2. Dial setting encoder and select the function code altered.
Note: See page 41 for Function Codes and Functions.
Setting Encoder
Dial
How to adjust the Function Set Valu
e