BFT ALTAIR User Manual

CONTROL UNIT
ALTAIR
D811321
05-05-02 Vers. 04

BFT ALTAIR Specifications

General

Model	ALTAIR
Frequency	50/60 Hz
Max. No. of Motors	2
Operating Temperature	-20°C to +55°C
Motor Power Supply	24V AC/DC

Summary

General Safety

Control Unit Technical Specifications

Terminal Board Connections

JP7 GND and Mains Supply

JP8 Motor Connections

Details connections for motor 1 and motor 2, including common terminals.

JP9 Blinker and Accessory Outputs

JP9 Warning Light and STOP Input

Motor Movement Control Parameters

Operation Time Settings

Automatic Closing Time (TCA)

Motor Torque Adjustment

Sets the pushing force electronically applied to each motor.

Programming Methods

Programming via UNIPRO

Connect UNIPRO programmer to set parameters and logic.

Programming via Onboard Display

Use the control unit's display to set functions and parameters.

Radio Transmitter Cloning

Rolling-Code Cloning Procedures

Procedures for cloning rolling-code transmitters via addition or master.

Fixed-Code Cloning Process

Process for cloning transmitters using fixed code configuration.

Collective Receivers

Collective Installation Setup

Setting up installations using collective and individual receivers.

Receiver Parameter Configuration

Programming Data Transfer

Centralised Serial Connection

Centralised Installation Programming via UNIPRO

Programming centralised installations using the UNIPRO programmer.

Centralised Installation Programming via Display

Programming centralised installations using the control unit's display.

Self-Diagnosis Menu

Parameter Menu and Settings

Work Time Configuration

Automatic Closing Time (TCA) Setting

Motor Torque Configuration

Adjusts the motor's pushing force as a percentage.

Radio Menu Functions

Adding Radio Control Devices

Reading Radio Control Data

Erasing Radio Control Memory

Self-Diagnosis Menu Interpretation

Error Code Interpretation

Control Unit Layout and Terminal Diagrams

Terminal Block Connections (Fig. 3)

Detailed diagrams of JP7, JP8, JP9, and JP4 terminal block connections.

Programming Accessories and Connections

UNIPRO/UNIRADIO Programmer Setup

Transmitter Programming Accessories

Installation Examples and Configurations

Collective Receiver Installation Example (Fig. 5)

Centralised Serial Connection Diagram (Fig. 7)

Diagram illustrating centralised serial connection configurations with ALTAIR/SCS units.