BFT PHOBOS N BT Installation Manual

3-7/8”
Phobos N BT gate bracket
5-3/8”
Phobos N L BT gate bracket
1) DETERMINE THE PROPER GEOMETRY FOR YOUR INSTALLATION. You can use the
table below to write down your dimensions.
3) BOLT AND/OR WELD THE GATE BRACKET ACCORDING TO YOUR GEOMETRY.
Remember to measure the distance to C with a fully closed gate.
WELD OR BOLT
4) INSTALL THE MAGNET HOLDER OVER THE GATE
BRACKET. Do not install before or right after welding. Wait
for bracket to cool down. Do not try to operate the actuators
without the magnet holder in place.
2) BOLT AND/OR WELD THE POST BRACKET ACCORDING TO YOUR GEOMETRY.
SIDE A B C ARB
RIGHT LEAF
LEFT LEAF
HINGE
OFFSET
MY GEOMETRY
INSTALLING THE MOUNTING BRACKETS12
C
OFFSET
ARB
A
B

BFT PHOBOS N BT Specifications

General

Brand	BFT
Model	PHOBOS N BT
Category	Gate Opener
Language	English