MAINTENANCE & TROUBLESHOOTING 15
Motor does not run.
Motor runs but gate does not move.
1. Verify that manual release lock is engaged. Page 14.
Gate moves but does not stop.
1. Check ECOSOL system
power.
2. Inspect motor wire
connections. Page 13.
3. Check for gate
obstructions and once
cleared depress the reset
button on ECOSOL
enclosure.
1. Verify that the limit
sensor are properly
adjusted. Page 14.
2. Make sure that the magnet holder is correctly
installed. Page 12.
DISCONNECT THE ECOSOL BATTERIES BEFORE PERFORMING ANY MAINTENANCE OR
REPAIR TO THE ACTUATORS
MAINTENANCE - Inspect the screw-drive gears for lubrication, debris and cleanness at least
once a year. For actuators installed in areas where dirt and dust are a concern, maintenance
should be done at shorter intervals. Keep the screw-drive lubricated using BFT grease
I101115. Do not apply grease if gears are dirty. If necessary, clean with solvent before
applying.
PHOBOS UNDERSIDE
SCREW-DRIVE
TROUBLESHOOTING
REFER TO ECOSOL LIBRA UL-R INSTALLATION MANUAL FOR ADDITIONAL TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
