WARNING! An incorrect installation or improper use of the product can cause damage to persons,
animals or property.
• Automation should be installed on a gate which is moving freely. Any issue with the smooth opening of
closing of a gate will not be corrected by adding automation.
• Scrap packing materials (plastic, cardboard, polystyrene etc) according to the provisions set out by
current standards. Keep nylon or polystyrene bags out of children’s reach.
• Keep this instruction manual for future reference.
• This product was exclusively designed and manufactured for the use specified in the present
documentation. Any other use not specified in this documentation could damage the product and be
dangerous.
• The Company declines all responsibility for any consequences resulting from improper use of the
product, or use which is different from that expected and specified in the present documentation.
• Do not install the product in explosive atmosphere.
• The Company declines all responsibility for any consequences resulting from failure to observe Good
Technical Practice when constructing closing structures (door, gates etc.), as well as from any
deformation which might occur during use.
• Follow and comply with national and/or local electrical codes when performing any electrical
installation.
• Disconnect the electrical power supply before carrying out any work on the installation. Also
disconnect any buffer batteries, if fitted.
• Fit all the safety devices (photocells, electric edges etc.) which are needed to protect the area from
any danger caused by squashing, conveying and shearing, according to and in compliance with the
applicable directives and technical standards.
• It is recommended to position at least one luminous signal indication device (blinker) where it can be
easily seen for additional safety
• The Company declines all responsibility with respect to the automation safety and correct operation
when other manufacturer’s components are used.
• Only use original parts for any maintenance or repair operation.
• Do not modify the automation components, unless explicitly authorized In writing by the Company.
• Instruct the product user about the control systems provided and the manual opening operation in
case of emergency.
• Anything which is not expressly provided for in the present instructions, is not allowed.
• Installation must be carried out using the safety devices and controls prescribed by the UL 325
Standard.
CHECKING INSTALLATION
Before the automated device is finally put into operation, perform the following checks meticulously:
• Make sure all components are fastened securely.
• Check that all safety devices (photocells, pneumatic safety edge, etc.) are working properly.
• Check the emergency operation control device.
• Check opening and closing operations with the control devices applied.
• Check the electronic logic for normal (or personalized) operation in the control panel.
ADJUSTING OPERATING FORCE
WARNING: Operating force is adjusted with extreme precision by means of the control unit’s electronic
control. Operation at the end of travel is adjusted electronically in the control panel. To provide good
anti-crush safety, the operating force must be slightly greater than that required to move the leaf both to
close and to open it.
CONTROL
There are various options when it comes to the control system (manual, remote control, access control
with magnetic badge, etc.) depending on the installation’s needs and characteristics. See the relevant
instructions for the various control system options. People who use the automated device must be
instructed how to control and operate it.
INSTALLATION SAFETY
6
To Next Page
Loading...
Need help?
General
