BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 9246
Workshop Press | 20 t
FE
ATURE
1. Used for parts straightening, bending and pressing.
2. Multi-position bed for work height adjustment.
3. With air pump can reduce labor and improve working efficiency
W
ARNING
• This press is designed and intended for use by properly trained and experienced personnel only.
If you are not familiar with the proper and safe operation of a hydraulic press, do not use until
proper training and knowledge has been obtained.
• Do not operate this press beyond it rated capacity.
• DO NOT compress springs or other objects that could be ejected from the press. DO NO
T
compress objects that could shatter.
• Please understand the max. working stroke before operate, Do not overload the max. working
stroke, so as not to damage parts.
• Check the press for loose or damaged parts before each operation. Replace damaged parts
and
tighten all loose bolts before operating.
• Some parts being pressed may have a tendency to pop out of the press or explode under
pressure. Protect yourself accordingly.
To Next Page
Need help?
General
