BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
USE
Remove sealing plug (A).
Turn the crankshaft in the normal direction of rotation
until the timing mark on the injection pump gear
matches the mark on the engine.
Insert the crankshaft locking pin into the engine housing
and tighten the pin by hand.
Slowly turn the crankshaft clockwise until the first
cylinder is at TDC (power stroke).
Install the crankshaft fixing tool as shown and secure
with two screws.
Loosen the crankshaft pulley bolt.
4
To Previous Page
Loading...
Need help?
General
