02530
I '
I
UNPACKING
AND
SET-UP
I
Your
BGW
Power Amplifier is shipped
in
an advanced packing
container.
SA
VE
THE
CONTAINER
AND
ALL PACKING MATERIAL!
The
container
should be saved in
the
event
the
unit is moved or shipped
at
some
future
date.
Replacement
containers
are
available from
BGW
Systems •
.Inspect
the
unit for damage in
transit
immediately upon
receipt.
If
damage is
found, notify
the
transportation
company
immediately.
Only
the
consignee may
institute
a claim
with
the
carrier
for shipping damage.
BGW
will
cooperate
fully in
such an
event.
Be
sure
to
save
the
container
as evidence of
damage
for
the
shipper
to inspect.
The amplifier's mounting position must
be
chosen
carefully,
so
that
the
air
flow
to
the
front and
rear
of
the
unit is not
restricted.
Inadequate ventilation may
cause
failure of
the
amplifier.
For
rack mounting,
the
four rubber
feet
on
the
bottom
of
the unit may
be removed and no hardware will be loosened inside
the
unit.
Do
not, however, use
the
front panel
as
the
sole support for
the
amplifier.
Side
rails or rack shelves should
be employed.
DO
NOT
PLUG THE AMPLIFIER
IN
YET!
All connections should be made before power is applied.
To Next Page
