configured. Speed dial entries can be added using the HD-1 interface; press the Directory/Speed Dial button then
use the Add button indicated on the HD-1 screen.
TEC-X and TEC-1 do not receive any programming from a Launch-configured TesiraFORTÉ X.
Firmware Update
Unconfigured or auto-configured TesiraFORTÉ X and Devio SCX devices support firmware updates via their web UI.
TesiraFORTÉ X uses the file tesiraforte-x_fw_web_v#-#-#.tfa for releases 4.1.2 and later. (Firmware releases 4.1.1
and earlier updates for both device types used the Devio SCX Firmware #.#.#.tfa file.) The tfa is a smaller file specific to
these hardware devices, allowing stable updates via the web interface.
The TesiraFORTÉ X and Devio SCX firmware can also be updated via Tesira software using the same Tesira
Firmware #.#.# .tfa2 file as other Tesira hardware uses. The tfa2 file contains firmware resources for all Tesira devices,
plus the Devio SCX devices.
Firmware must be release 4.0 or later to support the TesiraFORTÉ X and Devio SCX.
Always be sure to load the latest firmware to ensure hardware is up to date. Revision B Parle microphones and network
boxes require firmware version 4.2.1 or higher to function, they may appear to be unresponsive until the host
TesiraFORTÉ is updated.
• TesiraFORTÉ X Firmware
• Devio SCX Firmware
Input / output options
Dante and AVB
TesiraFORTÉ X is the first TesiraFORTÉ model to support AVB, Dante, and AES67 in one device, hosting a virtual
32x32 channel Dante interface as well as a 128x128 channel Tesira AVB interface. AES67 is supported in the Dante
interface and must be enabled using Dante Controller software. AES67 channels are counted against the Dante channel
count.
If additional AVB or Dante ports are required, up to (3) TesiraCONNECT TC-5 devices may be linked using P1 to
TesiraFORTÉ X P2-5 to increase the system's port count as needed. If multiple TC-5 are required, TC-5 may be
connected in a daisy chain, star, or hybrid daisy-chain/star configuration. TesiraFORTÉ X (P2-5) participates as a media
network switch in this topology.
Always use the non-PoE+ port (P1) of the TC-5 to link to the upstream device to maximize the available PoE+ ports.
Both Dante and AVB media protocols are passed on one network port. If stand-alone Dante and AVB networks are
https://support.biamp.com/Tesira/Miscellaneous/TesiraFORTE_X
Updated: Thu, 01 Dec 2022 17:48:44 GMT
Powered by
7
To Next Page
Loading...
