Bieffe EMILIO BF089E - Page 42

EMILIO
42
ENGLISH
While using the machine, when there is no water le inside the boiler, the red indicator will light
up (20). Before relling the boiler with water, be sure all the switches are o and the machine
is unplugged. Unscrew the safety cap (8) half a turn so that the le steam is released. Warning:
Do not take the safety cap o while steam, although few, is being released. Only aer all steam
is released and the boiler is cold, you can proceed with relling the boiler with water. Then close
without over ghtening the safety cap. Plug the machine to a grounded socket, set all the swi-
tches on and recommence.
Aer the work is done, switch o all switches and disconnect the mains plug. Then wait for the
appliance to cool down and clean it.
FOR BEST RESULTS, WE RECOMMEND THAT THE DIRT IS SOFTENED WITH THE STEAM JET
AND THEN RESIDUES ARE ASPIRED. THE WHOLE DIRT WILL GO INTO THE INOX BODY.
ATTENTION:
While using the as wet vacuum claner, please REMOVE the EMF lter placed inside the steel
drum. WHEN WET, THE FILTER MIGHT DAMAGE THE ENGINE. Leave the lter inside the
steel drum while using as vacuum cleaner.
if you need the machine to be always on, set the general switch on “1” to leave the ma-
chine in stand-by mode: the appliance will remain hot and in pressure, reducing wear and
electrical consumpon.
WARNING: NEVER WORK WITH EMPTY BOILER.