BIGREP ONE GENERATION 3 - Page 43

III. Soware BigRep
M374 Z grid strategy: save calibration grid. opti-
onal S parameter saves a custom file with
numerical extention
M374 S123
M375 Z grid strategy: load calibration grid.
optional S Parameter loads a pre saved
custom grid
M375 S123
M400 Wait for the queue to be empty before
answering "OK"
M400
M500 Save some volatile settings to an override
file
M500
M501 Load config-override file optionally spe-
cifying the extension
M501 - loads
cong-over-
ride, M501
test1 - loads
cong-override.
test1
M502 Delete the override file, reverting to config
settings at next reset
M502
M503 Display overridden settings if any
M503
M504 Save the settings to an override file with
specified extension
M504 test1 -
saves to con-
g-override.test1
M557 Defines probe points
M557 P1 X30 Y40.5
M561 clears the plane and the bed leveling is
disabled until G32 is run again
M561
M565 defines the probe osets from the nozzle
or tool head
M565 X3 Y4.5
Z-2.37
M600 Suspend print in progress (use console
command resume to continue)
M665 Set arm solution specific settings: Delta
- L<arm length> R<arm radius> Z<max
height>
M665 L341.0 R350
Z430
M666 On a delta sets trim values for the
endstops. (Positive values will crash physi-
cal endstops.)
M666 X-0.1 Y-0.2
Z- 0.3
M906 Set Current in milliamp for SPI drivers, only
if the driver is handled by the motorcontrol
module
M906 A1000 B1100
M907 Set Current control via digipot for each
axis (current in amps)
M907 X1.0 Y1.0
Z1.0 E1.5
III-F 7/8