IV. Setup BigRep
IV-B Operating Environment / Requirements
* 2016-04-07
Make sure the ground is leveled and has suicient load-bearing capacity!
Make sure there is enough free space between the machine and the ceiling (at
least 1m to the device)!
Take particular care to ensure that there is enough free space behind the control
cabinet at the back of the printer.
Make sure that there is a free zone of at least 1m around the device.
Once printing has started, the device may not be made accessible to any unau-
thorized persons!
To allow for a satisfactory printing process, make sure to:
› Avoid high humidity
› Keep the temperature in the operating environment between +15 °C and
+40 °C
› Avoid strong dras during the printing process
› Avoid direct exposure of the device to sunlight
› Not operate the device on surfaces particularly sensitive to vibrations
› Avoid serious indoor air pollution with dust (e.g. sanding dust)
Fig.: Free zone
IV-B 1/1
To Next Page
Loading...
