V. Maintenance BigRep
V-D Replacing Extruder
* 2016-04-07
Overview
No tools needed.
Also have a look at manual chapter 7.2.
IMPORTANT – Only change the extruder when machine is switched o
Procedure
1. Switch o the machine
2. Make sure that there is no Filament le in the extruder. If so please have a
look at manual.
3. Make sure that the hot ends cooled down.
4. Pull out both plugs at the extruders back
a. Turn the inner safety lock (red marked in right figure) anticlockwise and
then pull out the plug
V-D 1/2
To Next Page
Loading...
