V. Maintenance BigRep
V-F Lubricate
* 2016-04-07
Axis
Regularly clean and lubricate the X-guide rail (H), Y-guide rail (F), Z-lead spindles
(C), and Z-guide shas (B).
Please only use approved industrial lubricants. We recommend mineral oil-based
lubricants for rolling or plain bearings.
Regularly check the lubrication of individual components. Ensure that they are
always covered by a thin lubricating film.
Belts
Lubricate X, Y and Z belt with silicon spray.
To lubricate the Z-Belt, you have to open the cover at the top of the machine in
each edge.
To lubricate X and Y belts you have to open the cover of the axis.
V-F 1/1
To Next Page
Loading...
