V. Maintenance BigRep
V-G Belts
* 2016-04-07
Maintenance
All belts have to have a certain tension, measured in Hz. In order to measure the
tension you have to open the covers of the axis, manually hit the belt like a guitar
and measure the tension with a trumeter. The tension of X and Y Axis should be
around 15-18 Hz.
You can lower or increase the tension of the belts by using the screws at the
brackets which holds the belts to the axis.
Replacement
Belts can easily be replaced.
You have to open the cover of the axis, loosen the screws at the brackets (4 in
total), take away the old belt and guide the new belt through the pulley.
V-G 1/1
To Next Page
Loading...
