Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
7 / 7
Precautions
1. When plugging in the drive, be sure to orient the connector correctly to avoid
reversing the polarity and damaging the drive.
2. When using high voltage (greater than 24V) or high current (greater than 1.2A),
active cooling must be used to prevent the drive from overheating.
3. The factory default mode for the driver is SPI. This mode is recommended for
most users. If UART mode is required, manual soldering is necessary. It is not
recommended for users without soldering experience to attempt this, as it may
cause injury.
If you require additional resources for this product, please visit
https://github.com/bigtreetech/ to find them. If you cannot locate the resources you need,
please contact our customer support.
If you encounter other problems during use, please feel free to contact us, and we will be
more than happy to assist you. If you have any suggestions or feedback for our products,
we are open to hearing them. Thank you for choosing BIGTREETECH products!
To Previous Page
Loading...
