Need help?Do you have a question about the BIGTREETECH KRAKEN V1.0 and is the answer not in the manual?
General| Logic Voltage | 3.3V |
|---|---|
| Heating Bed Output | 1 |
| Endstop Inputs | 6 |
| SD Card | Yes |
| CAN Bus | Yes |
| Filament Break Detection | Yes |
| Power Loss Recovery | Yes |
| Automatic Shutdown | Yes |
| Bootloader | Yes |
| Motor Driver Interface | SPI |
| Supported Firmware | Marlin/Klipper |
Diagram showing the physical connections and ports on the Kraken board.
How to supply power to the Kraken board via USB, including indicator light status.
Configuration and usage of the onboard TMC2160 drivers in SPI mode for stepper motors.
Steps to set up the environment for compiling Marlin firmware.
How to obtain the Marlin firmware source code.
Detailed guide on configuring Marlin firmware for the Kraken board.
Instructions for opening the Marlin project in VS Code.
Setting up the platformio.ini file for Marlin compilation.
Setting the MOTHERBOARD and serial port configurations in Marlin.
Configuring stepper driver types and settings in Marlin firmware.
Enabling and configuring sensorless homing for stepper motors in Marlin.
Configuring temperature sensors (NTC or PT1000) in Marlin firmware.
Enabling and configuring the BLTouch probe for bed leveling.
Configuring the Auto Power Off relay control in Marlin.
Configuring NeoPixel RGB LEDs in Marlin firmware.
Setting up the standard filament runout sensor in Marlin.
Configuring the Smart Filament Sensor (SFS V1.0) in Marlin.
Steps for compiling and updating the Marlin firmware.
Guide to compiling Klipper firmware for the Kraken board.
Steps to configure Klipper by uploading and editing configuration files.
Instructions for updating firmware using a microSD card.
Guide for updating Klipper firmware using the DFU method.
To Next Page
