Need help?Do you have a question about the BIGTREETECH Octopus MAX EZ V1.0 and is the answer not in the manual?
General| Logic Voltage | 3.3V |
|---|---|
| Heater Outputs | 4 |
| Input Voltage | 12V-24V |
| Heater Bed Voltage | 12V-24V DC |
| Motor Driver | TMC2209 |
| Motor Driver Interface | UART |
| Temperature Sensor Interface | Thermistor, PT100, PT1000 |
| Display | LCD, TFT |
| Communication Interface | USB, UART |
| Firmware | Marlin, Klipper |
| Expandable Modules | Yes |
| Dimensions | 100mm x 100mm |
Details key features and capabilities of the Octopus MAX EZ control board.
Visual representation of the board's connection ports.
Detailed schematic showing pin assignments for all connectors.
Instructions for powering the board via USB connection.
Details on configuring stepper motor drivers, including UART/SPI modes.
Guide for setting up the development environment for Marlin firmware.
Instructions on obtaining the latest Marlin firmware version.
Steps to open and configure Marlin firmware project settings.
Guide to downloading suitable operating system images for Klipper.
Procedure for updating firmware using a microSD card.
Instructions for updating Klipper firmware using the DFU method.
To Next Page
