BIGTREETECH Octopus MAX EZ V1.0

BIGTREETECH Octopus MAX EZ V1.0 User Manual
25
If you are using displays like LCD2004, 12864, mini12864, etc., you can also
control RGB from your display directly.
#define LED_CONTROL_MENU // add led control to your menu.
Filament Sensor
Standard filament run out sensors are usually comprised of a microswitch which
signals the mainboard of filament status with High or Low level signal.
#define FILAMENT_RUNOUT_SENSOR // enable filament run out sensor
#define FIL_RUNOUT_ENABLED_DEFAULT true // true default to filament run
out sensor enabled
#define NUM_RUNOUT_SENSORS 1 // number of filament run out sensor
#define FIL_RUNOUT_STATE LOW // voltage level of the filament runout
sensor trigger signal. Set according to the actual situation of the module. If the
module sends a low level when the filament is abnormal, set it to LOW.