BIGTREETECH Octopus MAX EZ V1.0 User Manual

BIGTREETECH Octopus MAX EZ V1.0 User Manual
34
7.
Login as: pi password: raspberry
Compile Firmware
1. After SSH successfully connected to the Raspberry Pi, enter in terminal：
cd ~/klipper/
make menuconfig
Compile with the configuration shown below (if the options below are not
available, please update your Klipper source code to the newest version).
* [*] Enable extra low-level configuration options
* Micro-controller Architecture (STMicroelectronics STM32) --->
* Processor model (STM32H723) --->
* Bootloader offset (128KiB bootloader (SKR SE BX v2.0)) --->
* Clock Reference (25 MHz crystal) --->
* Communication interface (USB (on PA11/PA12)) --->
2. Press q to exit, and Yes when asked to save the configuration.
3. Run make to compile firmware, "klipper.bin" file will be generated in
home/pi/klipper/out folder when make is finished, download it onto your

BIGTREETECH Octopus MAX EZ V1.0 Specifications

General

Brand	BIGTREETECH
Model	Octopus MAX EZ V1.0
Category	Computer Hardware
Language	English