Need help?Do you have a question about the BIGTREETECH ADXL345 V2.0 and is the answer not in the manual?
General| Sensor Type | Accelerometer |
|---|---|
| Chip | ADXL345 |
| Communication Interface | I2C/SPI |
| Measurement Range | ±2g/±4g/±8g/±16g |
| Operating Temperature | -40°C to +85°C |
| Resolution | 13-bit |
| Output Data Rate | 0.1 Hz to 3200 Hz |
| Sensitivity | 3.9 mg/LSB (at ±16g) |
Key features of the ADXL345 V2.0 module, including BOOT button and ESD protection.
Technical specifications of the ADXL345 V2.0, covering dimensions, voltage, communication, and sensor details.
Details on supported firmware, currently limited to Klipper firmware for this product.
Detailed physical measurements and layout of the ADXL345 V2.0 module.
Overview of the external interfaces and connectors available on the ADXL345 V2.0 board.
Explanation of each pin's function and connection on the ADXL345 V2.0.
Guide to connecting the ADXL345 V2.0 to other boards like BTT Pi and Manta M8P.
Step-by-step guide to compiling the Klipper firmware for the ADXL345 V2.0.
Instructions for updating the ADXL345 V2.0 firmware using the DFU method.
Steps to configure the ADXL345 V2.0 module within the Klipper firmware setup.
Demonstrates two methods for physically installing the ADXL345 V2.0 module.
To Next Page
