Need help?Do you have a question about the BIGTREETECH Pi V1.2 and is the answer not in the manual?
General| Storage | MicroSD card slot |
|---|---|
| Ethernet | Gigabit Ethernet |
| GPIO | 40-pin GPIO header |
| Power Supply | 5V/3A via USB-C |
| USB Ports | 4 x USB 2.0 |
| HDMI Ports | 2 × micro-HDMI ports (up to 4Kp60 supported) |
| Video Output | 4K @ 60fps |
| Audio Output | HDMI and 3.5mm jack |
| Wireless | 802.11ac Wi-Fi |
| Dimensions | 85.6mm x 56.5mm |
| Operating System | Raspberry Pi OS |
| Board Type | Single Board Computer |
| RAM | 2GB, 4GB, or 8GB LPDDR4 |
Explains how to power the device using USB-C or DC 12V-24V input terminals.
Guides on downloading the OS image and necessary writing software like Raspberry Pi Imager or balenaEtcher.
Details the steps for writing the OS image using Raspberry Pi Imager and balenaEtcher.
Guides on configuring WiFi by editing the system.cfg file with SSID and password.
Explains how to compile MCU firmware using `make menuconfig` and `make` commands.
To Next Page
