深圳市必趣科技有限公司
BIGTREETECH
17 / 19
6. Login
Login as: biqu
Password: biqu
Compile MCU Firmware
1. After SSH is successfully connected to the device, enter in the terminal:
cd ~/klipper/
make menuconfig
The firmware is compiled based on the motherboard configuration, here we take
Manta M4P as an example:
* [*] Enable extra low-level configuration options
* Micro-controller Architecture (STMicroelectronics STM32) --->
* Processor model (STM32G0B1) --->
* Bootloader offset (8KiB bootloader) --->
* Clock Reference (8 MHz crystal) --->
* Communication interface (USB (on PA11/PA12)) --->
To Next Page
Loading...
