Need help?Do you have a question about the BIGTREETECH S2DW V1.0 and is the answer not in the manual?
General| Model | S2DW V1.0 |
|---|---|
| Interface | UART, SPI, I2C |
| Clock Speed | 72MHz |
| CAN Interface | Yes |
| Firmware | Marlin, Klipper |
| Connectivity | USB, CAN |
| Supported Stepper Drivers | TMC2209, TMC2208, A4988, DRV8825 |
| Input Voltage | 12V to 24V |
| Digital I/O Pins | Available, number varies based on configuration |
| Analog Input Pins | Available, number varies based on configuration |
Highlights include a reserved BOOT button, customizable solder points, and ESD protection for the USB port.
Lists key technical specifications like dimensions, microprocessor, voltages, sensor, and operating temperature.
States that the product currently only supports Klipper firmware.
Details the function of each pin on the module.
Explains how to connect the module to other devices.
Instructions for connecting the S2DW V1.0 to a BTT Pi V1.2 via Type-C.
Steps to connect the S2DW V1.0 to a Manta M8P using a Type-C cable.
Guide for connecting the S2DW V1.0 to a Manta M8P using soldering wires.
Step-by-step guide on how to compile Klipper firmware for the S2DW V1.0.
Instructions for updating the module's firmware using the DFU method.
Steps to configure the S2DW V1.0 within the Klipper firmware setup.
To Next Page
